Thursday, May 20, 2010

New Aircraft Design 70% More Fuel Efficient.

This work is presently conceptual but perhaps timely.  Converting concept to practical aircraft is pretty quick these days so we could see these craft a lot quicker than we are used to.

The massive fuel savings will serve to drive the present fleet into early obsolescence.  In short, this will be as sharp a conversion as the advent of the 747 in the mid sixties.  And in time, it will drive down the cost of air travel.

No one can fight a fifty percent fuel saving let alone a 70% fuel saving.

They are projecting 2035 for these craft.  I think we will see birds as quickly as 2020 simply because the fuel argument is just too compelling.  And it would give Boeing a massive jump on its rivals. Who would swiftly be playing catch up.

MIT-Led Team Designs Two Airplanes That Would Use 70% Less Fuel Than Current Models

15 May 2010

An MIT-led team has designed an airplane that is estimated to use 70% less fuel than current planes while also reducing noise and emission of NOx. The design was one of two that the team, led by faculty from the Department of Aeronautics and Astronautics, presented to NASA last month as part of a $2.1 million research contract to develop environmental and performance concepts that will help guide the agency’s aeronautics research over the next 25 years.

Known as “N+3” to denote three generations beyond today’s commercial transport fleet, the research program is aimed at identifying key technologies, such as advanced airframe configurations and propulsion systems, that will enable greener airplanes to take flight around 2035.

The D “double bubble” series design concept is based on a modified “tube-and-wing” structure that has a very wide fuselage to provide extra lift. The aircraft would be used for domestic flights to carry 180 passengers in a coach cabin roomier than that of a Boeing 737-800. Click to enlarge.

The H “hybrid wing body” series would replace the 777 class aircraft now used for international flights. The design features a triangular-shaped hybrid wing body aircraft that blends a wider fuselage with the wings for improved aerodyanmics. The large center body creates a forward lift that eliminates the need for a tail to balance the aircraft. The plane is designed to carry 350 passengers. Click to enlarge.

MIT was the only university to lead one of the six US teams that won contracts from NASA in October 2008. Four teams—led by MIT, Boeing, GE Aviation and Northrop Grumman, respectively—studied concepts for subsonic commercial planes, while teams led by Boeing and Lockheed-Martin studied concepts for supersonic commercial aircraft. MIT team members include Aurora Flight Sciences Corporation and Pratt & Whitney.

The objective was to develop concepts for, and evaluate the potential of, quieter subsonic commercial planes that would burn 70% less fuel and emit 75% less NOxthan today’s commercial planes. NASA also wanted an aircraft that could take off from shorter runways.

The MIT team met NASA’s challenge by developing two designs: the 180-passenger D “double bubble” series to replace the Boeing 737 class aircraft, currently used for domestic flights, and the 350 passenger H “hybrid wing body” series to replace the 777 class aircraft now used for international flights.
The engineers conceived of the D series by reconfiguring the conventional tube-and-wing structure. Instead of using a single fuselage cylinder, they used two partial cylinders placed side by side to create a wider structure whose cross-section resembles two soap bubbles joined together. They also moved the engines from the usual wing-mounted locations to the rear of the fuselage.

Unlike the engines on most transport aircraft that take in the high-speed, undisturbed air flow, the D-series engines take in slower moving air that is present in the wake of the fuselage. Known as the Boundary Layer Ingestion (BLI), this technique allows the engines to use less fuel for the same amount of thrust, although the design has several practical drawbacks, such as creating more engine stress.

According to Mark Drela, the Terry L. Kohler Professor of Fluid Dynamics and lead designer of the D series, the design mitigates some of the drawbacks of the BLI technique by traveling about 10% slower than a 737. To further reduce the drag and amount of fuel that the plane burns, the D series features longer, skinnier wings and a smaller tail.
Not only does the D series meet NASA’s long-term fuel burn, emissions reduction and runway length objectives, but it could also offer large benefits in the near future because the MIT team designed two versions: a higher technology version with 70% fuel-burn reduction, and a version that could be built with conventional aluminum and current jet technology that would burn 50% less fuel and might be more attractive as a lower risk, near-term alternative.

Carl Burleson, the director of the Federal Aviation Agency’s Office of Environment and Energy, said that in addition to its “really good environmental performance,” the D series is impressive because its bubble design is similar enough to the tube-and-wing structure of current planes that it should be easier to integrate into airport infrastructure than more radical designs. “You have to think about how an airport structure can support it,” he said. “For some other designs, you could have to fundamentally reshape the gates at airports because the planes are configured so differently.

Although the H series utilizes much of the same technology as the D series, including BLI, a larger design is needed for this plane to carry more passengers over longer distances. The MIT team designed a triangular-shaped hybrid wing body aircraft that blends a wider fuselage with the wings for improved aerodyanmics. The large center body creates a forward lift that eliminates the need for a tail to balance the aircraft.

The large structure also allows engineers to explore different propulsion architectures for the plane, such as a distributed system of multiple smaller engines. Although the H series meets NASA’s emissions-reduction and runway-length goals, the researchers said they will continue to improve the design to meet more of NASA’s objectives.

The MIT team expects to hear from NASA within the next several months about whether it has been selected for the second phase of the program, which will provide additional funds to one or two of the subsonic teams in 2011 to research and develop the technologies identified during the first phase. The researchers acknowledge that some propulsion system technology still needs to be explored. They have proposed evaluating the interactions between the propulsion system and the new aircraft using a large-scale NASA wind tunnel. Even if the MIT designs are not chosen for the second phase, the researchers hope to continue to develop them.


Andrew Jacob said...

Most of present technological vehicles waste the most of their energy capacity, All the best for you future research work.

Georgia Drivers Ed

David said...

We need to move more greener & need to reduce as much as possible pollution, this concept giving us a new hope that we come to one stage when our all vehicles, Aircraft's run on solar & wind energy with minimal use of fuel.
Nevada Learners Permit

Used cars said...

Thanks for the post against emissions. Keep posting. I follow you.

website development company said...

I hope that you can still provide in the future articles like that. I will subscribe in case you do.