Thursday, May 7, 2009

List of Active Fission and Fusion Projects

This is a welcome list of the high energy research projects currently underway and allows us to catch up on what is afoot. Serious money is been now devoted to the field and we can expect to see more avenues explored. I have reposted on some of these already but needed a reasonable working list. This gives us that.

Cold fusion has made a comeback in basic creditability, but suffers from its natural limitation of been a heat source and so far a modest one. If it can be also cheap then it has a great future in industrial heat source. It never was a great idea to move power over copper wires to a heating coil from any source and having a local cold fusion furnace that cannot pollute is a certain winner.

The work on pebble bed reactors is exciting and also continuing good news. While the USA went into nuclear hibernation, the rest of the world advanced the technology and we are now in sight of complete uranium consumption. This has a huge impact of the lifespan of our nuclear industry because although no one thinks that minable uranium is soon to be in short supply, the potential is certainly there. At the same time massive beach thorium deposits in India back stop the emergence of thorium reactor technology.

All this work is now in full flight and backed as national priorities.

What this all proves is that a lot of folks think high energy systems are possible and are willing to try to make it all happen. For once it is the best of times after two generations of nonsense.


May 04, 2009

http://nextbigfuture.com/2009/05/nuclear-fusion-and-new-nuclear-fission.html

(H/T to Torulf Greek who created several of the images of Bussard/IEC fusion) and found or created one of the tri-alpha energy images)
1. High Temperature Pebble Bed Reactors
China will be following up by developing factory mass production of pebble bed reactors and deploying several pebble bed reactors at some locations.(TRISO baseball size pellets used for the pebble bed reactors) are achieving 16% burn-up without failure. To provide some perspective, most light water fuels are only licensed to achieve about 5% burn-up. There is a $7 million project to work on achieving deep burn (60-70% burnup) of TRISO fuel pebbles. 3 to 20 times more uranium can be used in one pass through a reactor. The pebble bed reactors also are basically immune from meltdown. China has run a test where their 10 MW reactor had its coolant turned off and the reactor shutdown by itself.Higher temperatures mean more efficient conversion of heat to electricity and the reactors can be adapted more easily for industrial uses and could be swapped in to replace coal burners at coal plants. Coal plants could be more easily converted to be carbon free by re-using the site and the steam generators and the power grid connections.

2. Integral Fast Reactors
They could be used with deeper burning pebble bed reactors and with existing reactors to close the fuel cycle.
This reactor like the Integral Fast Reactor can burn up almost all of the nuclear fuel.
This system would also enable all of the uranium to be completely burned. Nuclear waste from current plants or waste (unburned fuel) that is currently in storage can also be burned in the fission part of this fusion-fission hybrid. The nuclear fusion part generates the neutrons that transmute the uranium.

https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEgErP-jWEDEq0XzqPFWFCXObYLqKo09ENwl5bTw_orqt6ekvCXyUkeOZoOwdxFTvy3JJ-qv0ZZInf5c9_9yQ8uuZA6_X9eyh4ioeN3OCSjavYA0caVJJnJ_VixG5OHsY6BBpjgplrL0ZltL/s1600-h/life2.jpg

5. Compact Tokomak Fusion-Fission Hybrid
6. Uranium from Seawater
Japan has a plan to scale up uranium from seawater by using modified seaweed as a source of biofuel and to trap uranium from seawater.Uranium in seawater is a 3.5 billion ton source which is being replenished by river runoff.There are a lot of regular uranium reserves and uranium in phosphate deposits and with the deeper burn and deep burn of uranium mentioned above (3-30 times more efficient usage of uranium and thorium) there will not be an urgent need for uranium from seawater. However, mastering this capability will ensure tens of thousands to billions of years of fuel supply. (Depending upon rate of usage.)

https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEg6arg-VQW2r07Lcib0JjPhHAeODBlPMWBo3ILfBNMQqPbryPk8wriTkt9hLkrGBZn0aR9BG2_fn1pU3K6430UX5s8AFuVmf7PLiNAkQ_3aNQmnORJHw9g3YGdSrt6W6Npls0Non27iHT0/s1600-h/uraniumseawater.jpg

7. Inertial Electrostatic (IEC/Bussard) Fusion

IEC fusion uses magnets to contain an electron cloud in the center. It is a variation on the electron gun and vacuum tube in television technology. Then they inject the fuel (deuterium or lithium, boron) as positive ions. The positive ions get attracted to the high negative charge at a speed sufficient for fusion. Speed and electron volt charge can be converted over to temperature. The electrons hitting the TV screen can be converted from electron volts to 200 million degrees.The old problem was that if you had a physical grid in the center then you could not get higher than 98% efficiency because ions would collide with the grid. The problem with grids is that the very best you can do is 2% electron losses (the 98% limit). With those kinds of losses net power is impossible. Losses have to get below 1 part in 100,000 or less to get net power. (99.999% efficiency) Bussard system uses magnets on the outside to contain the electrons and have the electrons go around and around 100,000 times before being lost outside the magnetic field.The fuel either comes in as ions from an ion gun or it comes in without a charge and some of it is ionized by collisions with the madly spinning electrons. The fuel is affected by the same forces as the electrons but a little differently because it is going much slower. About 64 times slower in the case of Deuterium fuel (a hydrogen with one neutron). Now these positively charged Deuterium ions are attracted to the virtual electrode (the electron cloud) in the center of the machine. So they come rushing in. If they come rushing in fast enough and hit each other just about dead on they join together and make a He3 nucleus (two protons and a neutron) and give off a high energy neutron.Ions that miss will go rushing through the center and then head for one of the grids. When the voltage field they traveled through equals the energy they had at the center of the machine the ions have given up their energy to the grids (which repel the ions), they then go heading back to the center of the machine where they have another chance at hitting another ion at high enough speed and close enough tocause a fusion.

https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEgdOJWF3wZnDDZiviWFJzv0SaO8TI9bbo-7zmqmYXW79FYNjW5kM7PuQn689ifA7ZRDy0Wl_kp7QvNmgZ91M_8DT0sepRw46RAON-jrqs8ZK6JgQjGmuDsysDc3q-X-38HVbb_zsnxub_A/s1600-h/IEC_Polywell.jpg

https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEjy2HFuHl18mEmIUvtLKV1N-aICKjrSuzgLoqwVLcYgAEXxQNfIgZmPIspqzy2sBZ9cqaNoKfIet1icXUDAGE-I6xUmxlTzC-2r3QwB6oZYoLa9u80xkhXPVqTQUi1rFQx1z6zl8v2dtXc/s1600-h/Dodekawell3.jpg


8. General Fusion
10. Focus Fusion

Lawrenceville Plasma Physics Inc., a small research and development company based in West Orange, NJ, has announced the initiation of a two-year-long experimental project to test the scientific feasibility of Focus Fusion, controlled nuclear fusion using the dense plasma focus (DPF) device and hydrogen-boron fuel. Hydrogen-boron fuel produces almost no neutrons and allows the direct conversion of energy into electricity. The goals of the experiment are first, to confirm the achievement the high temperatures first observed in previous experiments at Texas A&M University; second, to greatly increase the efficiency of energy transfer into the tiny plasmoid where the fusion reactions take place; third, to achieve the high magnetic fields needed for the quantum magnetic field effect which will reduce cooling of the plasma by X-ray emission; and finally, to use hydrogen-boron fuel to demonstrate greater fusion energy production than energy fed into the plasma (positive net energy production). The experiment will be carried out in an experimental facility in New Jersey using a newly-built dense plasma focus device capable of reaching peak currents of more than 2 MA. This will be the most powerful DPF in North America and the second most powerful in the world. For the millionth of the second that the DPF will be operating during each pulse, its capacitor bank will be supplying about one third as much electricity as all electric generators in the United States.

Eric Lerner, Lawrenceville Plasma Physics, Google Talk 64 minutes
11. Tri-alpha Energy
at

1 comment:

  1. Jed RothwellMay 7, 2009 at 12:07 PM

    Cold fusion is a heat source, but it has reached temperatures and power density as high as a fission reactor core, so if the reaction can be controlled it will be easy to generate electricity with it.

    See:

    http://lenr-canr.org

    ReplyDelete